Foundation Crack Repair
Sealing leaking cracks in poured walls and judging which cracks need a closer structural look. Call to connect with a local specialist serving Scranton and Lackawanna County.

Key points
- Polyurethane or epoxy injection for leaking poured-wall cracks
- Horizontal cracks and bowing call for a structural opinion first
- Block and stone walls usually need different repairs
- Document cracks with photos and dates to track change
Almost every concrete foundation develops cracks. Concrete shrinks as it cures, and soil, frost and settling add stress over the years. Most cracks are cosmetic. Some leak. A few deserve a closer look by a structural professional. Telling them apart is the first step.
Common crack types
- Thin vertical cracks in poured walls, often near windows or the middle of a long wall. Usually shrinkage. They may leak during wet periods.
- Diagonal cracks from window corners or wall ends. Often related to settling or stress concentration. Watch them over time.
- Stair-step cracks following mortar joints in block walls. Can indicate settling or soil pressure.
- Horizontal cracks along block or poured walls, sometimes with the wall leaning inward. These suggest soil pressure and call for a structural evaluation before any waterproofing.
- Floor cracks in the slab. Often shrinkage, but can let groundwater up under pressure.
How leaking poured-wall cracks are sealed
For a leaking crack in a poured concrete wall, injection is a common approach:
- The crack is cleaned and small ports are set along its length.
- The surface of the crack is sealed so material cannot escape.
- Polyurethane or epoxy is injected from the bottom up, filling the crack through the wall.
- After curing, ports are removed and the surface is finished.
Polyurethane expands and stays flexible, which suits cracks that may still move slightly or that are actively wet. Epoxy cures hard and can restore some strength to a crack, which may be preferred when structural bonding matters. A specialist can explain which suits your wall.
Block and stone walls are different
Injection works best on solid poured concrete. Hollow block walls and fieldstone walls, both common in older valley homes, do not hold injected material the same way. Cracks in those walls are usually addressed with repointing, interior drainage, wall membranes or structural reinforcement. See stone and block foundation repair.
Mine subsidence and cracks
Much of the Lackawanna Valley sits above old anthracite workings. Most foundation cracks here have ordinary causes such as shrinkage, settling or soil pressure. If you are concerned that ground movement could be related to old mines, a structural engineer is the right professional to evaluate it. Pennsylvania's Department of Environmental Protection runs a Mine Subsidence Insurance program, because most homeowners policies do not include this coverage, and the state site explains how to check whether an address is over or near a mined area. Read more in mine subsidence insurance basics.
Tracking cracks
Before calling, it helps to document what you see:
- Photograph each crack with a ruler or coin for scale.
- Mark the ends with a pencil and date them.
- Note whether the crack leaks, and after what kind of weather.
- Check whether doors or windows above have started sticking.
A crack that grows, widens or shifts over months tells a different story than one that has not changed in years.
Exterior causes still matter
Even after a crack is sealed, water will keep looking for a way in if it pools next to the foundation. Gutters, downspouts and grading, especially on sloped lots, are part of a lasting fix. See hillside and yard drainage.
Cracks at pipe penetrations and old openings
Older valley basements often have openings that were patched long ago: abandoned coal chutes, bricked-in windows, old sewer or water line entries. The patch material ages differently from the wall around it, and the seam becomes a crack that leaks. Sealing around active pipes usually involves specialized sealants or injection around the penetration, while abandoned openings may need to be rebuilt.
Seasonal timing
Cracks often leak most in March and April, when snowmelt and spring rain soak the ground. Injection can be done in any season because the work happens indoors, and some specialists prefer to work while a crack is actively wet so the leak path is easy to trace.
Questions to ask a specialist
- What type of crack is this, and what likely caused it?
- Is it structural, or a water problem only?
- Which injection material do you recommend, and why?
- Should a structural engineer look at it first?
- What exterior changes would reduce pressure on the wall?
Call to connect with a local specialist who repairs foundation cracks in Scranton and Lackawanna County homes.
Questions and answers
Are all foundation cracks a problem?
No. Many are shrinkage cracks that are cosmetic. Leaking cracks, widening cracks and horizontal cracks deserve attention.
What is the difference between epoxy and polyurethane injection?
Polyurethane expands and stays flexible, sealing active leaks. Epoxy cures hard and can bond the crack. The right choice depends on the crack.
Could a crack be caused by mine subsidence?
Most cracks have ordinary causes. If you suspect ground movement, have a structural engineer evaluate it and read about the state Mine Subsidence Insurance program.
Can cracks in block walls be injected?
Injection is mainly for solid poured concrete. Block walls usually need different repairs.
Communities served
Scranton, Dunmore, Clarks Summit, Dickson City, Old Forge, Taylor, Moosic, Throop, Olyphant, Carbondale, Archbald, Jessup, Clarks Green, Pittston.
Related services
Ready to talk to a specialist?
Call to connect with an independent local waterproofing provider.