Interior Drainage Systems
A perimeter channel under the basement floor that collects seepage and sends it to a sump before it spreads. Call to connect with a local specialist serving Scranton and Lackawanna County.

Key points
- Collects water at the floor edge, where most valley basements leak
- Works from inside, so steep yards and tight lots are not a barrier
- Pairs with a sump pit and a discharge line to daylight or the yard
- Often combined with a wall membrane on older stone or block
Walk into enough basements in Scranton, Dunmore or Taylor after a heavy rain and you notice the same pattern. The walls may be damp, but the water that actually collects on the floor usually arrives along the edge, where the wall meets the slab. An interior drainage system is built to catch water at exactly that line.
How an interior system is put together
The idea is simple, even if the work is not. A specialist cuts a strip of concrete along the inside of the foundation walls, digs a shallow trench down toward the footing, and lays a slotted pipe or a formed channel in washed stone. The trench is then patched with new concrete. Water that presses through the wall, under the footing or up at the cold joint drops into the channel and runs to a sump pit, where a pump lifts it out of the house.
Typical parts include:
- A collection channel along some or all of the perimeter.
- Clean stone around the pipe so silt does not clog it quickly.
- A wall drainage membrane, often a dimpled plastic sheet, that guides wall seepage down into the channel.
- Weep holes drilled into the bottom course of hollow block walls so trapped water can drain.
- Cleanouts so the line can be flushed later.
- A sealed sump basin and pump, with a discharge pipe leading outside.
Why it suits the Lackawanna Valley
Several local conditions make interior drainage a common recommendation here:
- Older foundations. Many homes in the valley date to the coal era. Their fieldstone, brick or early block walls were never built to stay dry, and original footing drains, if any were installed, often stopped working decades ago.
- Hillside lots. Homes along the valley walls often have a high side where groundwater moves downhill toward the foundation. Interior drainage relieves that pressure without excavating a steep yard.
- Tight spacing. In older neighborhoods, houses sit close together, with narrow side yards, porches and shared driveways. Interior work avoids digging along a neighbor's property line.
- Slow-draining soils. Glacial deposits and fill in parts of the valley can hold water against foundations for days after a storm.
Full perimeter or partial
Some basements only leak along one wall, usually the uphill side or the wall nearest a downspout. A partial system can make sense there. Others leak in several places, and a full perimeter system is the more predictable answer. A careful specialist will explain why they recommend one over the other, and what to expect at the ends of a partial run.
What interior drainage does not do
Interior drainage manages water that has already reached the foundation. It does not keep the outside of the wall dry, so a stone or block wall may still feel damp, which is one reason a wall membrane is often added. It also does not fix sewer backups, structural movement or surface water that pours in through a basement window or bulkhead door. Those need their own solutions.
The sump and discharge matter just as much
A drainage channel is only as good as the pump and pipe at the end of it. Ask about:
- The basin size and whether it has a sealed lid.
- The pump's capacity and switch type.
- A check valve to keep water from running back into the pit.
- Where the discharge line ends, and whether it is protected from ice in winter.
- Backup options if the power goes out during a storm.
On hillside lots, discharge routing deserves extra thought. Water released on the uphill side can simply soak back toward the house, and water sent downhill should not be aimed at a neighbor's foundation or across a sidewalk where it can form ice.
Living through the installation
Expect noise and dust while concrete is cut, though many crews use dust control. Items along the walls need to be moved, and finished walls may need to be opened near the floor. Most of the work stays inside, so the yard and landscaping are left alone. Ask how long concrete restoration takes and when the floor can be used normally again.
Questions to bring to the conversation
- Where is water entering, and how did you determine that?
- Will the system cover the full perimeter or part of it, and why?
- What happens to the hollow cores in my block walls?
- Is a wall membrane included?
- What pump and backup do you recommend for my home?
- How is the system maintained, and how often should it be checked?
Call to connect with a local waterproofing specialist who serves Scranton and the surrounding Lackawanna Valley. For background, read why valley basements take on water and what shapes the cost of a waterproofing project.
Questions and answers
Does interior drainage stop water from coming through the walls?
It collects water that reaches the wall and floor edge and sends it to a sump. A wall membrane is often added to direct wall seepage down into the channel.
Is interior drainage a good fit for old stone foundations?
It is commonly used with stone and block walls, sometimes after loose mortar is repointed. A specialist can tell you what your wall needs first.
Will my yard be dug up?
Interior systems are installed from inside the basement, so the yard usually stays intact.
How often does an interior system need maintenance?
Most need periodic sump testing and occasional flushing through cleanouts. Ask the installer for a schedule.
Communities served
Scranton, Dunmore, Clarks Summit, Dickson City, Old Forge, Taylor, Moosic, Throop, Olyphant, Carbondale, Archbald, Jessup, Clarks Green, Pittston.
Related services
Ready to talk to a specialist?
Call to connect with an independent local waterproofing provider.