Sump Pump Installation & Backups
Pits, pumps, check valves, alarms and backup pumps sized for spring thaw and summer downpours. Call to connect with a local specialist serving Scranton and Lackawanna County.

Key points
- Heart of any drainage system: the pump moves the water out
- Battery backups help during storm-related power outages
- Discharge routing is critical on sloped lots
- Alarms give early warning before water reaches the floor
A sump pump rarely gets attention until the day it stops. In the Lackawanna Valley, that day tends to arrive during a spring thaw, a stalled summer thunderstorm or the remnants of a tropical system, exactly when the pump is working hardest and the power is most likely to flicker. A well-planned sump setup reduces the chance of that surprise.
What a complete sump system includes
- The basin. A lined pit set below floor level, ideally large enough that the pump does not cycle on and off every few seconds.
- The primary pump. Usually a submersible unit with a float or electronic switch.
- A check valve. Keeps water in the discharge pipe from falling back into the pit when the pump stops.
- The discharge line. Carries water out of the house and away from the foundation.
- A sealed lid. Reduces humidity, odor and debris, and helps with radon control.
- A high-water alarm. Sounds, or sends a phone alert, if water rises above the normal level.
- A backup pump. Takes over if the main pump fails or the power goes out.
Sizing for local conditions
Pump capacity should match how much water the pit actually receives. A basement on the uphill side of a valley street, fed by groundwater moving down the slope, can see steady inflow for days after a storm. A basement on flatter ground may only need the pump occasionally. Signs that a pump is undersized or poorly matched include running constantly in wet weather, short cycling, or water rising in the pit faster than the pump can clear it.
Backup options
- Battery backup pumps sit in the same pit and run from a deep-cycle battery when the main pump cannot keep up or loses power. Batteries need periodic replacement.
- Water-powered backups use municipal water pressure to create suction. They avoid batteries but require adequate city water pressure and use water while running. They are not suited to homes on private wells.
- Generators can power the main pump during outages, but must always run outdoors, away from windows and doors.
Discharge routing on sloped lots
Many homes in Scranton's hill sections, Dunmore, the Abingtons and the boroughs along the valley walls sit on slopes. That changes where sump water should go:
- Water released uphill of the house can return to the foundation.
- Water sent downhill should not end up against a neighbor's wall or across a sidewalk.
- Long discharge lines on slopes need to drain fully so they do not hold water that turns to ice.
- Many municipalities do not allow sump water in the sanitary sewer.
A specialist can propose a route, such as a buried line to a pop-up emitter or a splash area on stable ground, that fits the slope.
Replacing an older pump
Older pits in valley homes are often small, unlined holes, sometimes with an aging pump wired directly into an outlet near the floor. When replacing a pump, it can be worth upgrading the basin, adding a check valve and lid, and confirming the outlet is protected by a GFCI device and located well above potential water levels.
Simple checks you can do
- Pour a bucket of water into the pit and watch the pump start, empty the pit and stop.
- Listen for grinding or rattling.
- Make sure the float moves without catching.
- Follow the discharge line outside and confirm it is clear.
- Test the alarm and backup battery.
The spring sump pump checklist walks through each step.
Pumps in homes that sit empty
Seasonal cabins in the hills, rental doubles and homes between owners can go weeks without anyone checking the basement. For those properties, a connected alarm that sends a text or app notification, a backup pump and a neighbor who can check in after big storms are simple protection against a surprise.
Double homes and shared walls
The valley has many side-by-side double homes. Each half may have its own sump, or one pit may serve both. If you own half of a double, find out where the neighboring pit is and where it discharges. A failed pump on one side can affect the other.
Questions to ask a specialist
- How did you size the pump for my basement?
- Would a larger basin reduce cycling?
- Which backup fits my home and utility service?
- Where will the discharge go, and how will it handle winter?
- How should I test the system, and how often?
Call to connect with a local specialist who installs and services sump systems around Scranton and Lackawanna County.
Questions and answers
How do I know if my sump pump is too small?
If it runs nonstop in wet weather or the water level rises faster than the pump clears it, the pump or basin may be undersized.
Is a battery backup worth it?
For finished basements, or homes that lose power during storms, a battery backup adds protection when it is needed most.
Can sump water go into the sewer?
Many municipalities prohibit connecting sump discharge to the sanitary sewer. Check local rules before routing it.
Where should sump water go on a hillside lot?
Away from the foundation and onto stable ground that slopes away, without sending it toward a neighbor's house or a walkway.
Communities served
Scranton, Dunmore, Clarks Summit, Dickson City, Old Forge, Taylor, Moosic, Throop, Olyphant, Carbondale, Archbald, Jessup, Clarks Green, Pittston.
Related services
Ready to talk to a specialist?
Call to connect with an independent local waterproofing provider.